DOT → LTC

What makes DOT -> LTC specific

DOT and LTC live on completely separate networks with no shared bridge or wrapped representation, so every swap here is a real cross-chain trade, not a contract call. DOT settles in roughly 6 second blocks with low fees and uses a 10-decimal native unit; LTC settles in 2.5 minute blocks with MWEB optionally available on supporting endpoints. Expect total swap time of 5-15 minutes once both confirmations clear.

Liquidity for this pair is moderate. Most aggregated routers price it as DOT -> BTC or USDT -> LTC under the hood, so the quoted rate already includes two spreads. That means small differences between providers compound: a 0.4 percent gap on the mid-rate is normal, a 1.5 percent gap means the route is thin.

What to check before sending

• Network match: DOT must be sent from a Polkadot relay chain address, not a parachain or an exchange-wrapped DOT on BSC or ETH. Wrong network = lost funds.
• LTC receive address: confirm whether the destination supports MWEB (ltc1 prefix with extended format) or only legacy and SegWit. Some swap services refuse MWEB outputs.
• Rate type: 'floating' tracks the market until confirmation, 'fixed' locks now but adds 0.5-1 percent buffer. For DOT's volatility, fixed is safer on amounts above ~200 DOT.
• Min and max: typical minimums sit around 5-10 DOT; maxes vary widely and thin liquidity above 5,000 DOT.
• Refund address: always provide one. If the deposit arrives outside the rate window or below minimum, this is the only way back.

Practical tip: unbond DOT well before swapping - the 28 day unstaking period catches people off guard. Once liquid, send a small test amount first if you're moving more than a few hundred DOT, since DOT's address format (SS58) is easy to truncate when copying.