USDT → NEAR

ordenar por

tipo de tasa

Flotante Fija

Cotizaciones a tasa de mercado (pueden cambiar antes de ejecutarse).

root@notkyc:~$ tasas en caché para todos · ttl 60s · 54s

#	Casa de cambio	Puntuación	Historial sin KYC?	Tasa	Recibes (1 USDT)	Límites (USDT)
1	OctoSwap MEJOR	A priv 87trust 70	// no on-platform swaps yet	1 USDT = 0.496771 NEAR	0.496771 NEAR	min 7000 · max 1200000	intercambiar en notkyc	intercambiar en OctoSwap →
2	XMRS	C priv 61trust 71	6/6 KYC-free	1 USDT = 0.4868 NEAR	0.4868 NEAR	min 100 · max 1000000	intercambiar en notkyc	intercambiar en XMRS →
3	SideShift	C priv 48trust 78	—	1 USDT = 0.48135798 NEAR	0.48135798 NEAR	min 27.24 · max 10219.593462		intercambiar en SideShift →

OctoSwap MEJOR A

Tasa1 USDT = 0.496771 NEAR

Recibes0.496771 NEAR

Límitesmin 7000 · max 1200000 USDT

intercambiar en notkyc intercambiar en OctoSwap →

XMRS C

Tasa1 USDT = 0.4868 NEAR

Recibes0.4868 NEAR

Límitesmin 100 · max 1000000 USDT

intercambiar en notkyc intercambiar en XMRS →

SideShift C

Tasa1 USDT = 0.48135798 NEAR

Recibes0.48135798 NEAR

Límitesmin 27.24 · max 10219.593462 USDT

intercambiar en SideShift →

Moving USDT into NEAR is a directional bet: you are converting a dollar-pegged stablecoin into a Layer-1 with sharded throughput, sub-second finality, and human-readable account names. Traders typically run this swap to accumulate NEAR ahead of staking (validators currently yield around 8-9 percent), to fund accounts on Aurora or NEAR-native dApps, or to rotate sidelined stablecoin liquidity into a mid-cap asset before a perceived ecosystem catalyst.

// sobre este par

USDT -> NEAR: what the pair actually involves

USDT exists on many chains (ERC20, TRC20, BEP20, Solana, Arbitrum, NEAR-native via Rainbow Bridge) but NEAR Protocol settles only on its own chain. Every aggregator route ends with a NEAR mainnet transaction crediting your implicit account or named account (yourname.near). That final leg is fast - blocks finalize in roughly 1-2 seconds and fees are fractions of a cent - so the bottleneck is always the source side.

Source-network choice drives your effective rate more than the headline quote:

TRC20 USDT: cheapest withdrawal, usually 1 USDT flat, 1-3 minute confirmation.
ERC20 USDT: highest gas exposure, can erase 5-15 USDT depending on mempool conditions.
BEP20 / Arbitrum / Solana USDT: low fees but fewer routing services support all of them for NEAR output.

Liquidity for USDT/NEAR is decent but not infinite. Orders above roughly 50,000 USDT often start showing visible slippage on float-rate routes, since aggregators pull from CEX order books where NEAR depth thins past the top few levels.

Choosing a route and sizing the swap

Check these before committing funds:

Rate type: fixed rates lock the quote but charge a wider spread; float rates track the market until execution and can drift 0.5-2 percent either way.
Rate-lock window: typically 10-15 minutes. If your USDT source chain is congested, fixed quotes can expire mid-transit and downgrade to float.
Refund address: always provide one on a chain you control. NEAR-side failures are rare, but USDT bridging issues do happen.
Destination format: confirm the service supports named accounts if you are sending to something.near, not just 64-character implicit addresses.
Min/max: NEAR's lower unit price means small swaps (under 20 USDT) sometimes fall below minimum thresholds after fees.

If you plan to stake immediately, leave at least 0.1 NEAR unstaked for transaction gas and storage deposits - NEAR charges storage rent per account and contract interaction.

// preguntas

Which USDT network gives the best effective rate when swapping to NEAR?

TRC20 is usually optimal for amounts under a few thousand dollars due to its 1 USDT flat withdrawal fee and fast confirmations. ERC20 only makes sense for very large swaps where the percentage cost of gas becomes negligible. Aggregator quotes already factor in network fees, so compare the final NEAR received, not the headline rate.

Can I send the swapped NEAR directly to a named account like myname.near?

Most aggregator routes accept named accounts, but some only validate 64-character implicit addresses. If your destination is a named account, confirm support before locking the quote. When in doubt, use the implicit address tied to your wallet and transfer internally afterward - implicit-to-named transfers on NEAR cost a fraction of a cent.

How long does a USDT to NEAR swap take end to end?

The NEAR leg finalizes in 1-2 seconds. Total time is dominated by USDT confirmations: roughly 2-5 minutes for TRC20, 3-10 minutes for ERC20 depending on gas tier, and 1-2 minutes for Solana or BEP20 USDT. Add 30-90 seconds for the aggregator's internal routing through its CEX or DEX backend.

What happens if NEAR's price moves during a float-rate swap?

Float rates execute at the market price when your USDT confirms, not when you got the quote. In a fast-moving market this can mean receiving 1-3 percent more or less NEAR than the initial estimate. If you need certainty - for example sizing a staking position - choose a fixed-rate route and complete the deposit within the lock window.

Is there a minimum amount that makes this swap worthwhile?

Below roughly 20-30 USDT, fixed network fees and aggregator spreads consume a meaningful share of the output. Most services enforce minimums in that range anyway. For staking, factor in that NEAR validators typically require small but non-zero delegation amounts and that you need to retain gas for the stake transaction itself.

Do I need an existing NEAR account before swapping?

Yes. NEAR accounts must be created on-chain before they can receive funds in some flows, though implicit accounts (the 64-character hex addresses) are created automatically on first deposit. If you want a human-readable account, register it through a NEAR wallet first, fund it with the swap, then optionally use it as your staking or dApp identity.

// relacionados